Pilot Pilot Pilot Pilot 2 Bolt 2 Bolt 4 Boltĭimen- Dimen- Dimen- Dimen- Type 2 Bolt Type 4 Bolt Type TABLE 1-DIMENSIONS OF 2 AND 4 BOLT PUMP AND MOTOR MOUNTING FLANGES Http:Copyright 1996 Society of Automotive Engineers, Inc.Ĥ.1.2 The number following the dash (-) states the number of mounting holes in the flange. SAE invites your written comments and suggestions. SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. Voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user.” SAE Technical Standards Board Rules provide that: “This report is published by SAE to advance the state of technical and engineering sciences. units are given for information purposes, and these appear in parentheses next to their SIĤ.1 Flange identification codes are found in Table 1.Ĥ.1.1 The number preceding the dash (-) is an approximation, in millimeters, of the mounting flange pilot SAE TSB 003-Rules for SAE Use of SI (Metric) UnitsĢ.1.2 ANSI PUBLICATIONS-Available from ANSI, 11 West 42nd Street, New York, NY 10036-8002.ĪNSI B92.1-1970-Involute Splines and Inspectionģ.1 The International System of Units (SI) is used herein in accordance with Reference 7.1.ģ.2 Customary U.S. SAE J1116 JUN86-Categories of Off-Road Self-Propelled Work Machines
Unless otherwise indicated the lastest revision of SAE publications shall apply.Ģ.1.1 SAE PUBLICATIONS-Available from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. Machines as described in categories 1 through 5 of SAE J1116 JUN86.ġ.1 Purpose-To provide a progression of standard mounting flanges and shafts that are dimensionallyĢ.1 Applicable Publications-The following publications form a part of the specification to the extent specified Scope-This SAE Standard applies to hydraulic pumps and motors used on off-road self-propelled work HYDRAULIC PUMP AND MOTOR MOUNTING AND DRIVE DIMENSIONSġ. Submitted for recognition as an American National Standard Max.400 Commonwealth Drive, Warrendale, PA 15096-0001 Maximum Oil Flow (continuous / intermittent): 2 Bolt SAE mounting flange.1 year warranty. Maximum pressure 1840 PSI continuous, maximum pressure 2425 PSI intermittent.
TB0130 TB Series Torqmotor, 1" 6B Spline, SAE "A" 2 Bolt, 130 cm3/revĬompatible for TB0130AS110AAAB Parker low speed, high torque hydraulic motor.
0 kommentar(er)
